How to apply Ox Pimples (no Sponge)

[pingpongrob]

Short Clip done by Pingpongrob & Supachop.

<a href="http://www.youtube.com/watch?v=s6xCE8T0-VI" target="_blank" class="aeva_link bbc_link new_win">http://www.youtube.com/watch?v=s6xCE8T0-VI</a>

All comments and questions welcome.

[Vinnie]

How is the Andro glue?
I like the way it goes on, and how you spread it.
Does it work well, and is it good value in your opinion?

[JKC]

looks like a bit of a faff to me, why don't people just get a proper rubber instead. >:D

[pingpongrob]

looks like a bit of a faff to me, why don't people just get a proper rubber instead. >:D

Now if this comment was made on another Forum, you would have been strung & quartered.

[RebornTTEvnglist]

looks like a bit of a faff to me, why don't people just get a proper rubber instead. >:D

JKC wash your mouth out with VOC glue!!  :o

I think Rob is right too!! 

[pingpongrob]

How is the Andro glue?
I like the way it goes on, and how you spread it.
Does it work well, and is it good value in your opinion?

Vincent, believe it or not most of the water based glues are made in Germany. (I said most - not all). So far from all the ones I've use - they all seem to be as good as each other. Most of the problems occur when people dont follow the instructions. (Cant blame them as there are no instructions printed on the bottle). Thats why forums like this are so good.

http://www.affordablett.com.au/smf/index.php/topic,408.0.html

[ulmo]

Hello,

i used allways the old permanent glue. I fix the ox sheet top town at the table and put some glue at the backside. After drying i put the glue at the blade and then i put the rubber at the blade after drying.

Uli

[pingpongrob]

Hello,

i used allways the old permanent glue. I fix the ox sheet top town at the table and put some glue at the backside. After drying i put the glue at the blade and then i put the rubber at the blade after drying.

Uli

Uli, not really anything new. Tell us how you actually apply the pimples sheet once the glue has dried.

[ulmo]

i roll the rubber and roll the rubber at the blade out. after rolling the pip at the blade i press the rubber on the blade with a bottle of wather.

uli

[RebornTTEvnglist]

I have a different method with a different "glue". I use water based silicon. Some on the rubber, some on the blade and just lay the base of the sheet onto the blade with the silicon wet still (very, very thin layer of silicon) and press down to the top and roll over with the silicon tube (like a liquid nails tube). Then I cut to the blade with sharp scissors. The bond with the silicon is easily broken by pulling at the sheet within a few minutes of applying, and is immediately playable without the sheet moving at all. And when time come to replace the rubber, it comes off pretty easily too.

[JT]

I saw rebs OX rubber and it had more air under it than blade, I've seen pancakes stuck to the roof better. :P

[RebornTTEvnglist]

I saw rebs OX rubber and it had more air under it than blade, I've seen pancakes stuck to the roof better. :P

What a liar!!

[RebornTTEvnglist]

What a liar!!

Oops, maybe that was before I re-glued it down

It was only where my finger goes that had lifted though.